Inhibitory Effect of Some Methylxanthines on Copper Corrosion in 1M HNO3: Experimental, DFT and QSPR Studies
DOI:
https://doi.org/10.21776/ub.jpacr.2021.010.01.548Keywords:
Methylxanthines, Mass loss measurements, DFT, QSPR, Copper corrosionAbstract
Inhibition corrosion of metals by using organic compounds has become an unavoidable means. So, in this work, the effect of methylxanthines on copper corrosion inhibition in 1M HNO3 was investigated by mass loss measurements and by two theoretical approaches: Density Functional Theory (DFT) and Quantitative Structure-Property Relationship (QSPR.) Quantum chemical calculations based on DFT at the B3LYP/6-31G(d) level permit to establish a correlation between the quantum chemical parameters and the experimental inhibition efficiency (IE %). It was found that inhibition efficiencies increase with increasing temperature and immersion time. In addition, the QSPR approach was used to find the best set of parameters for each molecule. This set of parameters make it possible to characterize the inhibition performance of the tested molecules solution significantly. The theoretical calculations are consistent with the experimental results.
Downloads
References
[1] Mu, G., Li, X., Qu, Q., and Zhou, J., Corros. Sci., 2006, 48(2), 445–459.
[2] Samiento-Bustos, E., Rodriguez, J.G., Uruchurtu, J., Dominguez- Patino, G., and Salinas-Bravo, V.M., Corros. Sci., 2008, 50(8), 2296–2303.
[3] Bastos, A.C., Ferreira, M.G., and Simoes, A.M., Corros. Sci., 2006, 48(6), 1500–1512.
[4] Broussard, G., Bramanti, O., and Marchese, F.M., Occup. Med., 1997, 47(6), 337–340.
[5] Lgaz, H., Salghi, R., Jodeh, S., and Hammouti, B., J. Mol. Liq. ,2017, 225, 271-280.
[6] Eddy, N.O., and Odoemelam, S.A., Adv. Nat. Appl. Sci, 2008, 2(3), 225-232.
[7] Eddy, N.O., Odoemelam, S.A., and Ekwumemgbo, P., Sci. Res. Essays, 2009, 4(1), 033–038.
[8] Ouattara, S., Tigori, M.A., Kouakou, V., Niamien, P.M., Trokourey, A., Pharm. Chem. J., 2018, 5(6), 29-44.
[9] Obot, I.B., Port. Electrochim. Acta, 2009, 27(5), 539–553.
[10] Obot, I.B., and Obi-Egbedi, N.O, Corros. Sci, 2010, 52(1), 198–204.
[11] Obot, I.B., Obi-Egbedi, N.O., and Umoren, S.A, Int. J. Electrochem. Sci., 2009, 4, 863–877.
[12] Prabhu, R.A., Shanbhag, A.V., and Venkatesha, T.V., J Appl Electrochem, 2007, 37, 491–497.
[13] Solmaz, R., Corros. Sci., 2014, 81, 75-84.
[14] Tigori, M.A., Bony, F.N., Niamien, P.M., Yapo, A.J., and Trokourey, A., Arch. Appl. Sci. Res, 2016, 8(5),18-32.
[15] Bouklah, M., Benchat, N., Aouniti, A., Hammouti, B., Benkaddour, M., Lagrénée, M., Vezin, H., and Bentiss, F., Prog. Org. Coat., 2004, 51(2), 118-124.
[16] Eddy, N.O., Ebenso, E.E., and Ibok, U.J., J. Appl. Electrochem., 2010, 40, 445-456.
[17] Wang, H.L., Liu, R.B., Xin, J, Media. Port. Electrochim. Acta, 2009, 27(5), 591-598.
[19] Karakus, M., Sahin, M., and Bilgic, S., Mater. Chem. Phys., 2005, 92(2-3), 565-575.
[20] Hosseini, S.M.A., and Azimi, A., Corros. Sci, 2009, 51(4), 728–732.
[21] Eddy, N.O., and Ebenso, E.E., Pig. Res. Technol., 2010, 39(2), 77-83.
[22] Hong, S., Chen, W., Zhang, Y., Luo, H.Q., Li, M., and Li, N.B., Corros. Sci., 2003, 66, 308–314.
[23] Hong, S., Chen, W., Luo, H.Q., and Li, N.B., Corros. Sci., 2012, 57, 270-276.
[24] Niamien, P.M., Essy, F.K., Trokourey, A., Yapi, A., Aka, H.K., and Diabate, D., Mater. Chem. Phys., 2012, 136 (1) 59-65.
[25] Khaled, K.F., Corros. Sci, 2010, 52(10) 3225–3234.
[26] Zarrouk, A., Warad, I., Hammouti., Dafali, A., Al-Deyab, S.S., and Benchat, N, Int. J. Electrochem. Sci., 2010, 5, 1516 – 1526.
[27] Guo, L., Zhu, S., Zhang, S., QiaoHe, Li, W,, Corros Sci,2014,87, 366-375
[28] Eddy, N.O., Ebenso, E.E., and Ibok U.J, J. Appl. Electrochem., 2010, 40, 445-456.
[29] Eddy, N.O., Ita, B.I., J. Mol. Mod, 2011, 17, 633-647.
[30] Sahin, M., Gece, F., and Bilgic, S., J. Appl. Electrochem., 2008, 38, 809-815.
[31] Yadav, D.K., Quraishi, M.A., and Maiti, B., Corros, Sci, 2011, 52(11), 3586-3598.
[32] Eddy, N.O., Mol. Simul., 2010, 35(5), 354-363.
[33] Khaled, K.F., Appl. Surf. Sci., 2010, 256(22), 6753-6763.
[34] Lukovits, I., Shaban, A., and Kalman, E., Russ. J. Electrochem, 2003, 39(2), 177-181.
[35] Hohenberg, P., and Kohn, W, Phys Rev., 1964, 136, B864.
[36] Frisch, M., et al, Gaussian 03 Revision B.05, 2003, Gaussian, Inc., Pittsburgh PA.
[37] Vera, L., Guzman, M., and Ortega-Luoni, P., J. Chil. Chem. Soc., 2006, 51(4), 1034-1039.
[38] Cardoso, S.P., Hollauer, E., Borges, L.E.P., and Gomes, J.A., J. Braz. Chem. Soc., 2006, 17(7), 1241-1249.
[39] Karelson, M., and Lobanov, V.S., Chem. Rev. 1996, 96(3), 1027-1043.
[40] Koopmans, T., Physica, 1934, 1(1-6), 104-113.
[41] Lesar, A., and Milosev, I., Chem. Phys. Let., 2009,483(4–6),198–203.
[42] Gece, G., and Bilgic, S., Corros Sci, 2009, 51(8), 1876–1878.
[43] Singh, A., Ansari, K.R., Kumar, A., Liu, W., Songsong, C., and Lin, Y., J. Alloys Compd., 2017, 72, 121-133.
[44] Lagren´ee, M., Mernari, B., Chaibi, N., Traisnel, M., Vezin, H., and Bentiss, F., Corros Sci, 2001, 43(5), 951–962.
[45] Quraishi, M.A., and Sardar, R., J. Appl. Electrochem., 2003, 33(12), 1163–1168.
[46] Khaled, K.F., Babić-Samardžija, K. and Hackerman, N., Electrochim. Acta, 2005, 50(12), 2515–2520.
[47] Obot, I.B., and Gasem, Z.M., Corros Sci , 2014, 83, 359-366.
[48] Obi-Egbedi N.O., and Obot I. B., Corros Sci, 2011, 53, 263-275.
[49] Saranya, J., Sounthari, P., Paranswari, K., and Chitra, S., Der Pharma Chemica, 2015, 8, 187-196.
[50] Parr, R.G., Donnelly, R.A., Levy, M., and Palke, W.E., J. Chem. Phys., 1978, 68(8), 3801–3807.
[51] Pearson, R. G., Proc. Natl. Acad. Sci., 1986, 83, 8440−8441.
[52] Pearson, R.G., J. Am. Chem. Soc., 1963, 85(22), 3533-3539.
[53] Pearson, R.G., Inorg. Chem. 1988, 27(4), 734–740.
[54] Michaelson, H.B., J. Appl. Phys., 1977, 48(11), 4729-4733.
[55] Kokalj, A., and Kovacevic, N., Chem. Phys. Lett.,2011, 507(1-3), 181-184.
[56] Lukovits, I., Kalman, E and F. Zucchi., Corrosion, 2001, 57(1),3–8.
[57] Parr, R.G., Szentpály, L.V., and Liu, S., J. Am. Chem. Soc.,1999, 121 (9), 1922-1924.
[58] Lukovits, I., Pálfi, K., Bakó, I., and Kálmán, E., corrosion. 1997, 53(12), 915-919.
Downloads
Published
Issue
Section
License
Authors who publish with this journal agree to the following terms:- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-NonCommercial 4.0 International License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).